Modular Design = Reduced Costs
Advanced Drying Technology
Gryphon dryers are produced in segments that are bolted together to form larger units, similar to lego blocks. The sections are built in 3, 5 or 10 foot widths, and bolt together in a series. The repeatable design greatly reduces manufacturing and installation costs. This design feature enables our technology to be shipped and installed in a fraction of the time of traditional dryers.
In addition, modules may be added to the installation at later stages to allow for fractional increases in production. This is a major advantage, as it allows for systematic increases in throughput with modest costs for both the capital and the required infrastructure.
System Sizes and Capacities (for typical biosolids applications)
0312 (3 feet by 12 feet): ~3 tons of evaporation per day
0318 (3 feet by 18 feet): ~5 tons of evaporation per day
0510 (5 feet by 10 feet): ~5 tons of evaporation per day
0520 (5 feet by 20 feet): ~10 tons of evaporation per day
0530 (5 feet by 30 feet): ~15 tons of evaporation per day
1020 (10 feet by 20 feet): ~20 tons of evaporation per day
1030 (10 feet by 30 feet): ~30 tons of evaporation per day
1040 (10 feet by 40 feet): ~40 tons of evaporation per day
1050 (10 feet by 50 feet): ~50 tons of evaporation per day
1060 (10 feet by 60 feet): ~60 tons of evaporation per day
Larger Model 20-series available upon request.
Installation Procedure
Depending upon the assembly (if the modules are placed in a series, stacked, or in parallel), the chambers are first placed in position and bolted together. Once in position, the lid structures are attached and then electronics and controls connected.
Once the electronics and controls are re-assembled at the site, water and air lines are connected to the unit. Lastly, conveyor belts are added to the assembly and the commissioning process begins. With the advanced design, Gryphon can manufacture systems in as low as 90 days and install systems in as little as two weeks.